Electric Steam Autoclave Sterilizers

The sterilizers are made of high quality cast aluminum alloy that resists aging and corrosion, ensuring years of trouble-free operation. Only the All American Sterilizers features an exclusive, precision machined "Metal-to-Metal" sealing system. Positive action clamping locks align the cover to the base forming a steam tight seal. Because no gasket is involved, the cover is always easily opened and closed. An accurate pressure gauge, pressure control valve, over-pressure safety plug, and cool Bakelite handles and wing nuts are all thoroughly tested features that assure safe operation with a minimum amount of attention.

Only a small amount of water is needed to create the dry steam. After achieving a minimum temperature of 250°F(121°C), and a pressure of 17psi, the dry steam penetrates the bandages or instruments, making them sterile in 35 minutes and ready for immediate use. No wiping is necessary to remove chemical residue or moisture, and cutting edges are not dulled.

All American Electric Sterilizers are available in both 120V & 240V models, and will operate on either 50Hz or 60Hz. All models include a 3-wire grounded cord and plug for safety. An optional support base elevates the sterilizer above the table or counter surface to prevent heat damage.

FDA Registration for All American Electric Steam Autoclave Sterilizers

• The All American Electric Steam Autoclaves are registered and listed with the FDA but not approved as per FDA code #807.85 "Exemption from Premarket Notification"
  
  
• There is no requirement for 510K FDA approval for the All American Sterilizers because according to the FDA rulings, these sterilizers were manufactured and commercially distributed before May 28, 1976 and did not require premarket approvals.
  
  
• The FDA clause regarding this can be found in Subpart E Premarket Notification Procedures Section 807.85 Exemption from pre market notification in Section 1.